Omron OMNUC G5 R88M-K series User Manual page 8

Safety Precautions Document
Do not place flammable materials near the motor, Servo Drive or Regeneration Resistor.
Fire may result.
Install the motor, Servo Drive and Regeneration Resistor to non-flammable materials such
as metals.
Fire may result.
When you perform a system configuration using the safety function, be sure to fully
understand the relevant safety standards and the descriptions in the operation manual, and
apply them to the system design.
Injury or damage may result.
Do not use the cable when it is laying in oil or water.
Electric shock, injury or fire may result.
Never connect a commercial power supply directly to the motor.
Fire or failure may result.
Do not perform wiring or any operation with wet hands.
Electric shock, injury or fire may result.
Do not touch the key grooves with bare hands if a motor with shaft-end key grooves is being
used.
Injury may result.
Use the motor and Servo Drive in the specified combination.
Fire or equipment damage may result.
Do not store or install the product in the following environment:
Location subject to direct sunlight
Location where the ambient temperature exceeds the specified level
Location where the relative humidity exceeds the specified level
Location subject to condensation due to the rapid temperature change
Location subject to corrosive or flammable gases
Location subject to higher levels of dust, salt content or iron dust
Location subject to splashes of water, oil, chemicals, etc.
Location where the product may receive vibration or impact directly
Installing or storing the product in these locations may result in fire, electric shock or
equipment damage.
The Servo Drive radiator, Regeneration Resistor, motor, etc. may become hot while the
power is supplied or remain hot for a while even after the power supply is cut off. Never touch
these components.
A burn injury may result.
6
OMNUC G5-Series AC Servo Drives Users Manual (Built-in MECHATROLINK-II communications type)
Danger
Caution