Omron OMNUC G5 R88M-K series User Manual page 11

Operation and Adjustment
Conduct a test operation after confirming that the equipment is not affected.
Equipment damage may result.
Before operating the product in an actual environment, check if it operates correctly based
on the parameters you have set.
Equipment damage may result.
Never adjust or set parameters to extreme values, as it will make the operation unstable.
Injury may result.
Separate the motor from the mechanical system and check its operation before installing the
motor to the machine.
Injury may result.
If an alarm generated, remove the cause of the alarm and ensure safety, and then reset the
alarm and restart the operation.
Injury may result.
Do not use the built-in brake of the motor for normal braking operation.
Failure may result.
Do not operate the Servomotor when an excessive load inertia is installed.
Failure may result.
Install safety devices to prevent idle running or lock of the electromagnetic brake or the gear
head, or leakage of grease from the gear head.
Injury, damage or taint damage may result.
If the Servo Drive fails, cut off the power supply to the Servo Drive on the power supply side.
Fire may result.
Do not turn ON and OFF the main Servo Drive power supply frequently.
Failure may result.
Maintenance and Inspection
After replacing the unit, transfer to the new unit all data needed to resume operation, before
restarting the operation.
Equipment damage may result.
Never repair the product by disassembling it.
Electric shock or injury may result.
Be sure to turn OFF the power supply when the unit is not going to be used for a prolonged
period of time.
Injury may result.
OMNUC G5-Series AC Servo Drives Users Manual (Built-in MECHATROLINK-II communications type)
Safety Precautions Document
Caution
Caution
9