Omron OMNUC G5 R88M-K series User Manual page 329

Pn614
Alarm Detection Allowable Time Setting
Setting
0 to 1000
range
 Set the allowable time required until the motor stops by an emergency stop due to an alarm.
 When he time exceeds the set value, the operation forcibly turns to an alarming state.
 When the parameter is set to 0, the protection by allowable time does not function.
 Refer to the Emergency Stop Operation at Alarms in "11-3 Alarms (P.11-6)".
Pn615
Overspeed Detection Level Setting at
Setting
0 to 20000
range
 If the motor speed exceeds the set value during an emergency stop due to an alarm, the
Overspeed 2 (Alarm No.26.1) occurs.
The overspeed detection level setting is 1.2 times the maximum motor rotation speed if this
parameter is set to 0.
This parameter should normally be set to 0. The setting should be changed only when it is
necessary to lower the overspeed detection level.
Refer to "Emergency Stop Operation at Alarms" (P.11-13) in "11-3 Alarms (P.11-6)".
Pn616
Unused
Setting

range
Pn617
Unused
Setting

range
Pn618
Power Supply ON Initialization Time
Setting
0 to 100
range
 Set initialization time after power supply ON to the standard 1.5 seconds plus some.
 Refer to the Control Output Sequence in "3-1 Servo Drive Specifications (P.3-1)" for the details at power
on.
Pn619
Unused
Setting

range
Pn620
Unused
Setting

range
Pn621
Unused
Setting

range
OMNUC G5-Series AC Servo Drives Users Manual (Built-in MECHATROLINK-II communications type)
Unit ms
Emergency
Stop
Unit r/min

Unit

Unit
Unit 0.1 s

Unit

Unit

Unit
8-7 Special Parameters
Default Data
200
setting attribute
Default Data
0
setting attribute
Default Data

setting attribute
Default Data

setting attribute
Default
Data
0
setting attribute
Default Data

setting attribute
Default Data

setting attribute
Default Data

setting attribute
All
B
All
A
All

All
8

All
R
All

All

All

8-54