Omron OMNUC G5 R88M-K series User Manual page 152

3-4 Cable and Connector Specifications
Wiring
This is an example to connect a host controller and the Servo Drive by the MECHATROLINK-
II Communications Cable.
3
Note 1.The cable between the two nodes (L1, L2 ... or Ln) must be 0.5 m or longer.
Note 2. The total length of the cable (L1  L2  ... Ln) must be equal to or shorter than 50 m.
3-71
NC Unit
L1
OMNUC G5-Series AC Servo Drives Users Manual (Built-in MECHATROLINK-II communications type)
L2 Ln
Terminating
Resistor