Omron OMNUC G5 R88M-K series User Manual page 154

3-4 Cable and Connector Specifications
Connector-Terminal Block Conversion Unit (XW2B-20Gx)
The Unit is used with a Connector Terminal Block Cable (XW2Z-xJ-B34). They convert the
control input signal (CN1) of the G5-series Servo Drive into a terminal block.
Terminal Block Models
XW2B-20G4
3
 Use 0.3 to 1.25 mm
 The wire inlet is 1.8 mm (height)  2.5 mm (width).
 Strip the insulation from the end of the wire for 6 mm as shown below.
3-73
Model
XW2B-20G4 M3 screw terminal block
XW2B-20G5 M3.5 screw terminal block
XW2D-20G6 M3 screw terminal block
Dimensions
Precautions for Correct Use
2
wire (AWG22 to 16).
OMNUC G5-Series AC Servo Drives Users Manual (Built-in MECHATROLINK-II communications type)
Description
Flat cable connector (MIL type plug)
3.5 67.5
2
1
1
2
5.08
6 mm
3.5
20
19
19
φ
2- 3.5
20
Terminal block