Omron OMNUC G5 R88M-K series User Manual page 4

Items Requiring Acknowledgment
Items Requiring Acknowledgment
1. Terms of Warranty
(1) Warranty period
The warranty period of this product is 1 year after its purchase or delivery to the specified
location.
(2) Scope of warranty
If the product fails during the above warranty period due to design, material or
workmanship, we will provide a replacement unit or repair the faulty product free of
charge at the location where you purchased the product.
Take note, however, that the following failures are excluded from the scope of warranty.
a) Failure due to use or handling of the product in any condition or environment not
b) Failure not caused by this product
c) Failure caused by any modification or repair not carried out by OMRON
d) Failure caused by any use not intended for this product
e) Failure that could not be predicted with the level of science and technology available
f) Failure caused by a natural disaster or any other reason for which OMRON is not held
Take note that this warranty applies to the product itself, and losses induced by a failure
of the product are excluded from the scope of warranty.
2. Limited Liability
(1) OMRON shall not assume any responsibility whatsoever for any special damage, indirect
damage or passive damage arising from this product.
(2) OMRON shall not assume any responsibility for programming done by individuals not
belonging to OMRON, if the product is programmable, or outcomes of such programming.
3. Conditions for Intended Application
(1) If this product is combined with other product, the customer must check the standards and
regulations applicable to such combination. The customer must also check the compatibility
of this product with any system, machinery or device used by the customer. If the above
actions are not taken, OMRON shall not assume any responsibility regarding the
compatibility of this product.
(2) If the product is used in the following applications, consult your OMRON sales representative
to check the necessary items according to the specification sheet, etc. Also make sure the
product is used within the specified ratings and performance ranges with an ample margin
and implement safety measures, such as designing a safety circuit, to minimize danger
should the product fail.
a) Used in any outdoor application, application subject to potential chemical
b) Nuclear power control equipment, incineration equipment, railway, aircraft and vehicle
c) System, machinery or device that may threaten human life or property
d) Gas, water or electricity supply system, system operated continuously for 24 hours or
e) Any other application where a high level of safety corresponding to a) to d) above is
(3) If the customer wishes to use this product in any application that may threaten human life or
property, be sure to confirm beforehand that the entire system is designed in such a way to
notify dangers or ensure the necessary level of safety via design redundancy, and that the
product is wired and installed appropriately in the system according to the intended
2
specified in the catalog, operation manual, etc.
when the product was shipped from OMRON
responsible
contamination or electrical interference, or in any condition or environment not
specified in the catalog, operation manual, etc.
equipment, medical machinery, entertainment machinery, safety system or any other
device controlled by an administrative agency or industry regulation
any other equipment requiring high reliability
required
OMNUC G5-Series AC Servo Drives Users Manual (Built-in MECHATROLINK-II communications type)