Ipv6 Router Ospf Area - Allied Telesis AT-x510-28GTX Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
6
IPV ROUTER OSPF AREA

ipv6 router ospf area

Overview Use this command to enable IPv6 OSPF routing on an interface.
Use the no variant of this command to disable IPv6 OSPF routing on an interface.
Syntax ipv6 router ospf area <area-id> [tag <process-id>] [instance
<inst-id>]
no ipv6 router ospf area <area-id>
Defaults IPv6 OSPF routing is disabled by default.
When enabling IPv6 OSPF routing:
•
•
Mode Interface Configuration for a VLAN interface.
Usage When enabling IPv6 OSPF routing on an interface, specifying the area-ID is
mandatory, but the Process tag and Instance are optional.
See the
and examples.
The following commands enable IPv6 OSPF on VLAN interface vlan2, OSPF area
Examples
1, tag PT2, and instance 2:
awplus#
awplus(config)#
awplus(config-if)#
C613-50102-01 REV C
Parameter Description
<area-id>
The ID of the IPv6 OSPF routing area. Can be entered as either an
IPv4 A.B.C.D address format, or as an unsigned integer in the
range, 0 to 4294967295. Use either of the following forms when
entering an area-ID:
• area-id <A.B.C.D> where A.B.C.D is a number entered in IPv4
address format.
• area-id <0 to 4294967295>.
<process-id>
The process tag denotes a separate router process. It can comprise
any string of alphanumeric characters.
Note that this tag is local to the router on which it is set and does
not appear in any OSPF packets or LSA.
<instance-id> The OSPF instance ID, entered as an integer between 0 and 255.
This is the value that will appear in the instance field of the IPv6
OSPF hello packet.
the process-tag will default to a null value if not set.
the Instance ID defaults to 0 if not set.
OSPFv3 Feature Overview and Configuration Guide
configure terminal
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ipv6 router ospf area 1 tag PT2 instance-id 2
for more information
1048