Distribute-List (Ipv6 Ospf) - Allied Telesis AT-x510-28GTX Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
- (IP 6 OSPF)
DISTRIBUTE LIST V

distribute-list (IPv6 OSPF)

Overview Use this command in Router Configuration mode to filter incoming or outgoing
OSPFv3 route updates from the networks as defined in an associated access-list.
The entities that are used to perform filtering are ACLs (Access Control Lists), which
match on certain attributes in the routes that are being transferred. For
information about ACLs, see the
Use the no variant of this command in Router Configuration mode to disable this
feature for networks as defined in an associated access-list.
distribute-list <access-list> in
Syntax
no distribute-list [<access-list>] in
distribute-list <access-list> out {connected|ospf
[<process-tag>]|rip|static}
no distribute-list <access-list> out {connected|ospf
[<process-tag>]|rip|static}
Default Disabled
Mode Router Configuration
Usage This command applies filtering to the transfer of routing information between
OSPFv3 and the IPv6 route table. You can apply filtering in either direction, from
OSPFv3 to the IPv6 route table using an in distribute-list, or from the IPv6 route
table to OSPFv3 using an out distribute-list.
The effect of an in filter is that some route information that OSPFv3 has learned
from LSA updates will not be installed into the IPv6 route table. The effect of an out
filter is that some route information that could be redistributed to OSPFv3 will not
be redistributed to OSPFv3.
C613-50102-01 REV C
Parameter
<access-list>
in
out
connected
ospf
<process-tag>
rip
static
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ACL Feature Overview and Configuration
Description
Specifies the IPv6 access-list number or name to use. The
specified access list defines which networks are received and
which are suppressed.
Indicates that this applies to incoming advertised routes.
Indicates that this applies to outgoing advertised routes.
Specify the redistribution of connected routes.
Specify the redistribution of OSPFv3 routes.
Optionally specify an OSPFv3 process tag for OSPFv3 routes.
Specify the redistribution of RIPng routes.
Specify the redistribution of connected routes.
Guide.
1031