Install Collection Tube Racks - Teledyne CombiFlash Rf User Manual

Section 2 Preparation: Rf + , Rf + Lumen, Rf+ PurIon, and EZ Prep Systems

2.10 Install Collection Tube Racks

Before beginning a run, you must load collection racks with
tubes onto the system's fraction collector tray.
Your system was shipped with two collection tube racks. The
following tube rack sets are available:
• 60-5237-013 – Two racks for 13 x 100 mm test tubes
(8 mL). Total tubes: 216.
• 60-5237-061 – Two racks for 16 x 100 mm test tubes
(14 mL). Total tubes: 150.
• 60-5237-031 – Two racks for 16 x 125 mm test tubes
(15.5 mL). Total tubes: 150.
• 60-5237-032 – Two racks for 16 x 150/160 mm test
tubes (18 mL). Total tubes: 150.
• 60-5237-033 – Two racks for 18 x 150 mm test tubes
(25 mL). Total tubes: 140.
• 60-5237-034 – Two racks for 18 x 180 mm test tubes
(30 mL). Total tubes: 140.
• 60-5237-035 – Two racks for 25 x 150 mm vials (50
mL). Total vials: 60.
• 60-5237-040 – One rack for twelve 480 mL French
square bottles.
• 60-5394-469 – Two racks for 20 mL (28 x 61 mm)
scintillation vials. Total vials: 54.
• 60-5394-468 – Two racks for 40 mL (28 x 95 mm)
scintillation vials. Total vials: 54.
To load the racks:
1. Insert test tubes, vials, or bottles into the rack (Fig. 2-7).
Risk of broken glass or equipment damage. Do not load test tubes
longer than the length listed on the tube size label.
CAUTION
2-15