Teledyne CombiFlash Rf User Manual page 135

+
CombiFlash® Rf User Manual
column media and size. The column should match the
one that will be used for the run. You may override the
detected column size by selecting a different size or
media. See also: R
[ -
ON LINE
[ -
ON LINE
• Sample Name — The sample name is a text entry box
in which you can label the run. Type a unique descriptor.
PeakTrak saves the run information under this name.
Therefore, PeakTrak cannot accept any characters that
are reserved by the operating system (* ? / \, etc.). If you
do not type a Sample Name, PeakTrak will generate a
date/time stamp for the name when you click the Play
button to begin the run.
• Flow Rate — Type or select the desired flow rate for the
run. When using the Isco default column methods, the
system sets the flow rate to the optimum flow rate of the
column.
• Detector — (Rf+ systems, including those equipped
with 4x) Reports the current peak detection mode. To
change the peak detection settings, open the M
E
DITOR [6.3.2]
• Solvent A — Select the desired solvent from the list.
The solvents in the list are those defined by the
C
ONFIGURATION [6.3.13]
selecting a solvent, see the S
table.
• Solvent B — Select the desired solvent from the list.
6.3.1.3 Run Control Buttons
From left to right, the control buttons are:
• Play — The Play button starts or resumes the run. After
a run has started, this button is replaced by the Pause
button.
• Pause — The Pause button holds the %B at the current
value while the system continues to operate (sometimes
called an isocratic hold). Note that pausing the run
extends the run length. While in the Paused state, you
can resume the gradient by clicking the Play button, or
stop the run by clicking the Stop button. If you resume
6-14
S
EDI
and A R
] BOUT EDI
.
]
window.
R C
EP F OLUMN
S R C
EP F OLUMN
window. For assistance in
S
OLVENT
S G
ELECTION UIDE
D
ETECTION
ETHOD
ELECTION [ -
ON LINE
]