Method File - Teledyne CombiFlash Rf User Manual

+
CombiFlash® Rf User Manual
• System Status — PeakTrak displays the system status
to the right of the current method. Status messages may
include:
• system mode
• current position in a run, expressed in time or column
volumes
• current %B
• flow rate
• Main region — This area is where you can view or
modify method file settings. Frequently used method
settings are displayed on the M
Advanced method settings are displayed on the M
E
DITOR [6.3.2]
Many of the P
elements, or a subset of them. Note that the available
commands and options will change according to the active
window, the state of the system, and the current file.

6.1.2 Method File

PeakTrak controls the separation runs performed by the
system through a Method file. The system uses the method file
to direct the system operation after you click the Play button.
PeakTrak categorizes the method settings as Basic or
Advanced. Basic settings are the frequently used controls
accessed through the M
E
DITOR [6.3.2]
Method files are stored by the system and can be opened for
review, reuse, or modification. To open a method file, use the
F >O
ILE
transferred to the system from an external storage device
using the F
Method files use an *.mtd filename extension.
6.1.2.1 Default Methods
With the exception of the Rf 150, when PeakTrak is started,
and every time a RediSep Rf column is inserted, the system
loads a default method. A default method contains Teledyne
Isco's recommended basic and advanced settings for the use of
RediSep Rf columns on the system. There is a default method
6-2
window.
T
EAK RAK
window to access the Advanced settings.
menu command. Method files can be
PEN [6.2.1.2]
>I
ILE MPORT
W
AIN
W contain these main
INDOWS [6.3]
W
AIN INDOW [6.3.1]
M
ETHOD [6.2.1.9]
.
INDOW [6.3.1]
ETHOD
. Use the M
ETHOD
menu command.