Remote Interfaces; Network Configuration - Teledyne CombiFlash Rf User Manual

This section provides instructions for controlling the
CombiFlash Rf system through a remote interface. The system
can be accessed by several personal computers through a
corporate network, or by a single personal computer (PC)
through a direct connection.

7.1 Network Configuration

Note
The procedures described in this section will require assistance
from your network administrator. Contact your Information
Technology department before proceeding.
The system has a factory-assigned IP address—192.168.1.51.
In many cases, this address must be reconfigured for use on a
corporate network. To reconfigure the IP address:
1. From the touch screen panel, select the
Tools>Configuration menu command.
2. Select the Network Configuration tab.
3. Select Static IP as the Network Type.
Note
The CombiFlash Rf system also provides limited support for
DCHP connections. If DHCP is desired, select DCHP as the
network type and skip steps 4 through 7. The system will display
instructions required to complete a DHCP connection.
4. Enter the IP Address, Netmask, and Gateway information
provided by your network administrator.
CombiFlash
Section 7 Remote Interfaces
User Manual
+
® Rf
7-1