Teledyne CombiFlash Rf User Manual page 118

The options available on the alert message will vary
depending on when the condition occurs (before or during a
run) and which method (measured level or estimated usage
rate) indicated the condition.
To clear the alert message, the user must select one of the
options below.
• Continue – Select this option after you have added
more solvent to the container. After selecting this option
the system measures the solvent level again. If the level
is sufficient to complete the run, the run continues. If
not sufficient, the system displays the alert message
again.
• Ignore – This option is available when the estimated
usage rates indicates that the solvent levels are
insufficient. Select Ignore to clear the message and
continue the run. The system then ignores the estimated
solvent usage rate for the remainder of the run, but
continues to measure the solvent level. Should the level
become insufficient, the system will display another
alert message.
• Disable – Select this option to turn off solvent level
measurements and estimated solvent usage rates for the
remainder of the run.
• Cancel – This option appears before the run is started.
Select this option to cancel the run and return to the
main window which will display the current method.
Section 5 Operation
5-15