Table of Contents
Advertisement
2.10 Install Collection Tube
Racks
EAR99 Technology Technology Subject to Restrictions Contained on the Cover Page
Before beginning a run, you must load collection racks with tubes
onto the system's fraction collector tray.
Your system was shipped with two collection tube racks. The
following tube rack sets are available:
• 60-5237-013 – Two racks for 13 x 100 mm test tubes
(8 mL). Total tubes: 216.
• 60-5237-061 – Two racks for 16 x 100 mm test tubes
(14 mL). Total tubes: 150.
• 60-5237-031 – Two racks for 16 x 125 mm test tubes
(15.5 mL). Total tubes: 150.
• 60-5237-032 – Two racks for 16 x 150/160 mm test tubes
(18 mL). Total tubes: 150.
• 60-5237-033 – Two racks for 18 x 150 mm test tubes
(25 mL). Total tubes: 140.
• 60-5237-034 – Two racks for 18 x 180 mm test tubes
(30 mL). Total tubes: 140.
• 60-5237-035 – Two racks for 25 x 150 mm vials (50 mL).
Total vials: 60.
• 60-5237-040 – One rack for twelve 480 mL French
square bottles.
• 60-5394-469 – Two racks for 20 mL (28 x 61 mm) scintil-
lation vials. Total vials: 54.
• 60-5394-468 – Two racks for 40 mL (28 x 95 mm) scintil-
lation vials. Total vials: 54.
To load the racks:
1. Insert test tubes, vials, or bottles into the rack (Figure
2-13). The system assumes all tube positions have tubes. If
any tubes are missing, it is possible to have a fluid spill
when the fraction collection system advances to that posi-
tion
Risk of broken glass or equipment damage. Do not load test
tubes longer than the length listed on the tube size label.
CombiFlash NextGen Systems
Section 2 Preparation
CAUTION
2-13
Advertisement
Table of Contents
