Set Administrator Password; User Management - Teledyne CombiFlash Rf User Manual

Enable Rapid Equilibration Select this option to turn on rapid
equilibration. When enabled, this time-saving feature pumps
solvent at the maximum flow rate during column
equilibration. Note that some column sizes and types might be
adversely affected by high flow rates.
Default MS Graph settings The X-AXIS START control denotes
the starting mass displayed in the mass spectrum graph. The
X-AXIS END control denotes the ending mass displayed in the
mass spectrum graph. In either case, the entire mass
spectrum (50 Da through 1200 (2000 Da PURION L only)

6.3.14 Set Administrator Password

This window, opened by selecting the T
A
DMINISTRATOR
enter and change the system password, and to enable
password protection for the default methods.
To enter or change a password:
1. Type the password.
The factory default password is combiflash.
2.Type the password again to verify your entry.
3.To protect the Default methods select the "Require
Password For Editing Default Methods" option.
4.Click the OK button to save your settings and close the
window.
The following menu commands will require a password before
displaying the requested window:
• T
OOLS
• T
OOLS
• H
ELP
• T
OOLS
protects the current password.

6.3.15 User Management

Use the T
open a window from which you can add and remove system
users. When you add a user, the system will create a user
folder that becomes the data path for that user. User
P
ASSWORD [6.2.4.6]
>E D
DIT EFAULTS [6.2.4.4]
>U M
SER ANAGEMENT [6.2.4.7]
>S
ERVICE [6.2.5.2]
>S A
ET DMINISTRATOR
>U M
OOLS SER
Section 6 User Help Reference
menu command, is used to
P
ASSWORD [6.2.4.6]
ANAGEMENT [6.2.4.7]
>S
OOLS ET
. This
menu command to
6-41