Table of Contents
Advertisement
+
CombiFlash® Rf
User Manual
An incorrectly installed rack will cause the rack to be misaligned
under the fraction collector arm. Misaligned racks might cause
fractions to miss the tube opening or deposit in the wrong tube.
Always ensure the tube size label is visible (that is, facing outward)
and the rack is pushed in until it is seated.
3.9 Turn on Power
The system's power switch is located just below the touch
screen panel.
1. Turn the switch to the ON position. The system will begin
its startup routine which includes self diagnostics.
2. Monitor the movement of the fraction collector arm. The
arm should move to the left rear corner of the fraction
collector area.
You should not hear any grinding noises during the homing
sequence. If grinding is heard there is a problem with the homing
of the fraction collector arm. Contact the factory for assistance.
3. The system is ready for operation when the PeakTrak
screen is displayed.
3.10 Configure the System
Before operating the system, it should be configured for the
desired operation. To configure the system, open the
Configuration window by selecting Tools > Configuration from
the PeakTrak menu.
The configuration window has three tabs: Instrument
Configuration, Network Configuration, and User Preferences.
Network Configuration settings are discussed later in
Section 7, R
Adjust the following (sections 3.10.1 through 3.10.6) on the
Instrument Configuration and User Preferences tabs for the
desired operation and then click OK to save the settings.
Some configuration settings do not take effect until the system
is restarted. After completing sections 3.10.1 through 3.10.6,
follow the instructions in section 3.10.7.
3-12
I
EMOTE
NTERFACES
CAUTION
CAUTION
.
Advertisement
Table of Contents
