Teledyne CombiFlash Rf User Manual page 137

+
CombiFlash® Rf User Manual
• All — Click this button to collect all fluids in the fraction
collection tubes.
• Peaks — Click this button to collect only eluted peaks in
the fraction collection tubes.
• None — Click this button to divert all fluids to the
waste port.
6.3.1.5 Peak Collection Data
Peak Collection data is displayed in the Main window after a
run. You may also open a R
previous runs.
Clicking on a test tube with the mass spectrum window
displayed displays the mass spectrum for compounds eluted
into that tube (PurIon systems only). Clicking on adjacent
tubes allows a user to determine which fractions may
potentially contain impurities.
The peak collection data is displayed on the left side of the
Main window:
• Rack and tube information — Collected peaks are
color coded in the rack diagram so that you can easily
locate the peaks of interest. The tube colors correspond
to the color bars under the peaks displayed on the
chromatogram. If during the run more than one set of
tube racks was filled, use the Next and Previous Rack
buttons to view the additional racks. The table below the
rack diagram displays the peak data in tabular form.
• Display Method — Click the Display Method button to
view a summary of the peak detection and collection
settings for the run. You can return to the rack and tube
display by clicking the Display Rack button.
See Also:
• P
EAK
• S
TARTING A RUN USING DEFAULT SETTINGS [6.4.1]
• R
EAL
• M
ETHOD
6-16
T M O
RAK ENU PTIONS [6.2]
- G
TIME RADIENT
E
DITOR [6.3.2]
F
UN ILE [6.1.3]
E
DITING [6.4.6]
for advanced functions
for viewing data from