Teledyne CombiFlash Rf User Manual page 141

Table of Contents

Advertisement

+
CombiFlash® Rf
User Manual
point to any desired position. Click the insert button
once for each gradient point that must be added to the
plot area.
• Delete —Click this button to enable the gradient point
delete mode. When this mode is active, the system will
delete the point nearest the next click on the gradient
curve. Click the Delete button once for each point that
must be deleted from the plot area.
• Run Length — Type or select the length of the run.
Note that this will change the scale of the X-axis on the
gradient. Points that define the gradient will be
automatically scaled to fit the new run length. The run
length can be expressed in minutes or C
[
-
ON
LINE
Length units by changing the C
settings.
• Solvent A — Select the desired solvent from the list.
The available solvents are those defined by the
C
ONFIGURATION [6.3.13]
• Solvent B — Select the desired solvent from the list.
You can program mid-run solvent B changes by clicking
the Edit Gradient button to open the G
• Edit Gradient — Although the gradient may be edited
directly within the plot area, you can also edit the
gradient in tabular form. Click this button to open the
G
RADIENT
equipped with 4x, the Gradient table also lets you
program solvent changes in the gradient.
For complete instructions on defining gradient curves, see
D
EFINING A
Gradient Table The gradient table depicts the points that
define the gradient curve in a tabular format. From this table
you can change Solvent B (Rf+ systems, including those
equipped with 4x), the duration, and %B concentration of any
point on the curve. To do so, select the new value for a gradient
point. Changes that you make to the table will be reflected in
the gradient plot area.
You can also change the number of points on the curve by
inserting or deleting rows in the table. To change the number
6-20
(CV). You can configure PeakTrak's default Run
]
T
. On Rf+ systems, including those
ABLE
G
RADIENT [6.4.5]
ONFIGURATION [6.3.13]
settings.
.
V
OLUMN
OLUMES
T
RADIENT
ABLE
.

Advertisement

Table of Contents
loading

Table of Contents