Method Editor - Teledyne CombiFlash Rf User Manual

6.3.2 Method Editor

The Method Editor window has several sections. The B
BAR [6.3.2.1]
file operations, a G
D
ATA [6.3.4]
Below the button bar are the R
R N
UN OTES [6.3.2.3]
G
RADIENT
C
OLLECTION [6.3.2.5]
6.3.2.1 Button bar
The Method Editor button bar contains the following:
• New — (Rf+ systems, including those equipped with 4x)
Click this button to open a new method file using the
default method settings for the detected column media
and size.
• Open — Click this button to open a method file stored
on the system's internal hard drive.
• Save — Click this button to save any modifications to
the current method file. Note that if you attempt to save
modifications to a default method file, the F
window will open instead so you can rename the file.
This preserves the default method. If you do wish to edit
and save the system's default methods, use the
"T
OOLS
• Save As — Click this button to open the F
window. From this window you can rename the current
method and save it on the system's internal storage.
• Exit — Click this button to close the Method Editor and
return to the M
• Gradient Optimizer — Click this button to open the
G
RADIENT
produces an optimized gradient optimized based on your
TLC retention factor data.
• Column Data — (Rf+ systems, including those
equipped with 4x) Click this button to open the C
D
ATA [6.3.4]
about the column installed in the system.
at the top of the window gives you quick access to
RADIENT
(Rf+ systems, including those equipped with 4x).
. The lower part of the window contains the
P A
LOT REA [6.3.2.4]
and P
>E D
DIT EFAULTS [6.2.4.4]
W
AIN INDOW [6.3.1]
O
PTIMIZER [6.3.3]
window. This window reports information
Section 6 User Help Reference
O
PTIMIZER [6.3.3]
S
UN ETTINGS [6.3.2.2]
and settings for P
D
EAK ETECTION [6.3.2.6]
" command instead.
.
window. This feature
UTTON
, and C
OLUMN
and the
EAK
.
ILES [6.3.6]
ILES [6.3.6]
OLUMN
6-17