Table of Contents
Advertisement
+
CombiFlash® Rf
User Manual
6.3.5 Batch
The Batch tab contains the controls to stage and run
sequential separations on systems with a 4x Module.
6.3.5.1 Queue
The Queue section of this tab lets you enable column positions
and specify operating parameters.
• Queue — Check the box by the column positions that
are to be run. Note that the Rf 4x system performs the
separations sequentially. Columns can be run in any
order. Column positions are run in the order clicked, as
seen from top to bottom in the queue. As column runs
are finished, they can be replaced with new runs that
can be added to the queue.
• Sample Name — The sample name is a text entry box
in which you can label the run. Type a unique descriptor.
PeakTrak saves the run information under this name.
Therefore, PeakTrak cannot accept any characters that
are reserved for the operating system (* ? / \, etc.).
If you do not type a Sample Name, PeakTrak will
generate a date/time stamp for the name when you begin
the run.
• RediSep — Select the column that will be used for the
run. See also: C
• Loading Type— Select the type of injection.
• Start Tube — Select Next Tube to begin at the next
available tube in the current rack or Next Rack to begin
with the first tube in the next rack.
6.3.5.2 Gradient Plot Area
The Gradient Plot Area is the same as the one displayed on
the tabs for each column position. The display shows the
current channel. The top corner displays the current system
pressure.
6.3.5.3 Run Control Buttons
The Run Control Buttons allow you to control the operation of
the system.
6-26
F
R
OMBI
LASH
F
C
OMPONENTS [
ON
.
-
]
LINE
Advertisement
Table of Contents
