Teledyne CombiFlash Rf User Manual page 31

or its fittings leak, liquids will drain from this port to
protect internal components.
Discontinue use of the CombiFlash Rf
at the Pump Drain. Contact Teledyne Isco technical service for
assistance with correcting the leak.
Figure 1-11 Optional CombiFlash Rf
30. Waste Level Sense – The system uses air or user-supplied
gas to measure the hydrostatic pressure of the waste above
the level sense line end. The system will suspend operation
when this level is too high. Four ports allow you monitor
the level of each waste container on the Rf
31. Column Waste – Waste fluids are sent out ports 1 through
4. Tubing connected to these ports are paired with the
waste level sense air lines and routed to a collection
container for each channel.
32. From Rf
fluid from the diverter valve on the fraction collector arm.
CAUTION
30
37
36
35
+
– This port on the Column Waste block receives
Section 1 Introduction
+
Lumen if liquid is present
31
32
33
34
+
4x Module Features (Back)
+
4x system.
1-23