Table of Contents
Advertisement
Figure 3-3 Preparing a bulkhead fitting connection
b. Fully insert the tubing into the threaded bulkhead
fitting on the back panel of the system.
c. Finger-tighten the nut onto the threaded bulkhead
fitting. This will seat the ferrule in the fitting.
2. Route the tubing and insert the weighted end into the
user-supplied waste container.
3.6 Connect and Route Drain Lines
Risk of fire or equipment damage. Failure to connect drain lines
may allow organic solvents to pool in unsafe areas, creating a
potential for dangerous levels of flammable vapors. Improper
draining may damage the instrument's internal components.
Section 3 Preparation: Rf 150 Systems
WARNING
3-7
Advertisement
Table of Contents
