Bleeder Screw Assembly Note
1. Assemble the bleeder screw to the caliper using
the SST.
Tightening torque
6.99.8 N·m {7199 kgf·cm, 6286 in·lbf}
REAR BRAKE (DISC) INSPECTION
End Of Sie
Brake Judder Repair Hint
1. (See
P17 FRONT BRAKE (DISC)
Disc Plate Thickness Inspection
Caution
• • • • Ecessive runout may result if the disc plate is removed from the vehicle then machined. Machine
the disc plate while installed on the vehicle.
1. Measure the thickness of the disc plate.
• If the thickness is not within the specification, replace the disc plate.
Minimum
8 mm {0.31 in}
Minimum thickness after machining using a brake lathe on-vehicle
8.8 mm {0.35 in}
Disc Pad Thickness Inspection
1. Jack up the front of the vehicle and support it with safety stands.
2. Remove the wheel and tires.
3. Verify the remaining thickness of the pads.
Minimum thickness
2.0 mm {0.079 in} min.
4. Replace the pads as a set: right and left wheels, if
either one is at or less than the minimum
thickness.
End Of Sie
CONVENTIONAL BRAKE SYSTEM
INSPECTION.)
A6E6912W049
A6E691226980W01
P
X3U411WAS
P23