Installation When Using Tcp/Ip (Lpd/Port 9100); Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox DocuPrint CM505 da Administrator's Manual

Installation When Using TCP/IP (LPD/Port 9100)

This section describes how to install the machine using TCP/IP.
The following shows the reference section for each procedure.

Step 1 Preparations................................................................................................................... 265

Step 2 Configuration on the Machine ...................................................................................... 265

Step 3 Configuration on the Computer .................................................................................... 266
CentreWare Internet Services Setting Items ............................................................................ 266
Step 1 Preparations
The following items are required to use the machine via TCP/IP (LPD/Port 9100).
TCP/IP network environment
The Driver CD Kit (provided with the machine)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use TCP/IP (LPD/Port 9100)
on the machine. Enable the LPD Port or the Port 9100 port, and then configure TCP/IP
settings.
Note
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet
Services Setting Items" (P.266). For information on how to configure the setting using the Driver CD
Kit, refer to the manual contained in the Driver CD Kit.
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
3) Select [Tools] on the [Services Home] screen.
2
Enable the LPD port or Port 9100 port as appropriate.
In this example, the LPD port is enabled.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [LPD], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for
• You can configure the settings using CentreWare Internet Services or the Driver CD Kit.
• The default user ID is "11111".
• The default passcode is "x-admin".

Installation When Using TCP/IP (LPD/Port 9100)

7
265