Authentication/Security Settings; System Administrator Settings - Fuji Xerox apeosport-iv C5570 Administrator's Manual

5 Tools

Authentication/Security Settings

In [Authentication/Security Settings], you can configure the authentication and security
settings.
For more information about the feature, refer to "Authentication and Accounting Features" (P.363).
The following shows the reference section for each setting.

System Administrator Settings..................................................................................................262

Authentication...........................................................................................................................263
Allow User to Disable Active Settings .....................................................................................270
Job Status Default .....................................................................................................................270
Overwrite Hard Disk.................................................................................................................271
1
On the [Tools] screen, select [Authentication/Security Settings].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.114).
2
Select an item to set or change.
System Administrator Settings
In [System Administrator Settings], you can set the system administrator ID and
5
passcode.
We recommend setting the system administrator ID and passcode to prevent
unauthorized setting changes and ensure security.
System Administrator's Login ID
Set the system administrator's user ID. Enter the ID from 1 to 32 single-byte characters.
Note
1
Select [System Administrator's Login ID].
2
Select [On].
3
Select [Keyboard].
4
Enter the system administrator's ID with up
to 32 characters, and then select [Save].
5
Repeat steps 3 and 4 to re-enter the same
system administrator's ID in [Re-enter
System Administrator's Login ID].
6
Select [Save].
7
A confirmation window appears. Select [Yes] to confirm your entry.
System Administrator's Passcode
Set the passcode for the System Administration mode.
Setting a passcode is strongly recommended to enhance security.
Note
The system administrator's passcode set here is used when [Passcode Entry from Control
Panel] is set to [On] under [Authentication/Security Settings] > [Passcode Policy].
Set the passcode after setting the system administrator's user ID. You can set the passcode
from 4 to 12 numeric digits.
262
• The default of the system administrator's user ID is "11111".
• The default of the system administrator's passcode is "x-admin".