Honda 2005-2008 RX500 FA Service Manual page 87

'61HN252' by American Honda Motor Co. - Page 87 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
OIL CHANGE
Place the vehicle on a level surface.
Remove the oil filler cap and drain bolt to drain the
oil.
When the oil is completely drained, install the drain
bolt with a new sealing washer.
Tighten the drain bolt to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Fill the final gear case with the recommended oil
(page 3-18).
OIL CAPACITY:
75 cm (2.5 US oz, 2.6 Imp oz) at draining
3
100 cm (3.4 US oz, 3.5 Imp oz) at disassembly
3
Install the oil filler cap with a new O-ring (page 3-
18).
DIFFERENTIAL OIL
LEVEL CHECK
Place the vehicle on a level surface.
Remove the oil filler cap.
Check that the oil level is up to the lower edge of the
oil filler hole.
Check for leaks if the oil level is low.
Pour the oil through the filler hole until it reaches
the lower edge of the hole.
RECOMMENDED OIL: Hypoid gear oil SAE #80
Coat a new O-ring with grease and install it into the
oil filler cap groove.
Install the oil filler cap and tighten it to the specified
torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
O-RING
OIL FILLER CAP
MAINTENANCE
SEALING WASHER
DRAIN BOLT
OIL FILLER CAP
3-19
3/9/2008 10:41 PM