Honda 2005-2008 RX500 FA Service Manual page 297

'61HN252' by American Honda Motor Co. - Page 297 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
Install the snap ring into the groove properly with
the chamfered edge facing up.
Coat new dust seal lips with grease and install them
(the upper seal is flush with the frame edge and the
lower seal is fully seated onto the bearing).
INSTALLATION
Apply grease to the shaft bushing inner surface.
Install the shaft bushing onto the steering shaft with
the "arrow" mark facing up.
Install steering shaft holder B onto the frame.
Install the steering shaft into the shaft bearing.
Install steering shaft holder A.
Install and tighten the two bolts.
TORQUE: 32 N·m (3.3 kgf·m, 24 lbf·ft)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
FRONT WHEEL/SUSPENSION/STEERING
BUSHING
ARROW
MARK
SNAP RING
DUST SEALS
STEERING SHAFT
STEERING SHAFT HOLDER B
BOLTS
STEERING SHAFT HOLDER A
14-29
3/9/2008 11:05 PM