Honda 2005-2008 RX500 FA Service Manual page 505

'61HN252' by American Honda Motor Co. - Page 505 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
7. Angle Sensor Resistance Inspection 2
Remove the angle sensor (page 24-41).
Check that the resistance at the angle sensor ter-
minal varies while turning the sensor joint.
Connection: Yellow/blue (+) Green/yellow ()
Standard: 0 to 1.6 2.4 kΩ (20°C/60°F)
Is there normal condition and standard resis-
tance?
Faulty angle sensor After replace-
No
ment, perform initial setting procedure
(page 24-6)
GO TO STEP 8.
YES
8. System Failure Reproduction
Install the angle sensor and connect all connec-
tors.
Turn the ignition switch ON.
Check the gear position indicator.
Is the problem code blink indicated?
· No problem (Temporary failure)
NO
· Erase the failure code (page 24-9)
Faulty ECM After replacement, per-
YES
form initial setting procedure.
PROBLEM CODE 7: ESP SHIFT SWITCH
SYSTEM
1. ESP Shift Switch Connection Inspection
Check for loose or poor contact on the ECM 21P
(Black) connector.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
G/Y Y/Bu
GEAR POSITION INDICATOR
ECM 21P (BLACK) CONNECTOR
'05, '06 shown:
HONDAMATIC
JOINT
24-27
3/9/2008 11:29 PM