Honda 2005-2008 RX500 FA Service Manual page 313

'61HN252' by American Honda Motor Co. - Page 313 of 540
[2005-2008] [TRX500 FA/FGA]
SWINGARM
1 of 1
Apply grease to new dust seal lips and install the
dust seals into the lower pivot until they are flush
with the pivot surfaces.
Install the pivot collar.
INSTALLATION
Install the rear shock absorber onto upper mounting
stud of the frame.
Install the lower mounting bolt and tighten it.
TORQUE: 44 N·m (4.5 kgf·m, 33 lbf·ft)
Install the washer and upper mounting nut and
tighten the nut.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
REMOVAL
Remove the final drive assembly (page 18-9).
Remove the breather hoses from the clamps on the
swingarm.
Remove the band screw and universal joint boot
band.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
REAR WHEEL/SUSPENSION
UPPER MOUNTING NUT/WASHER
CLAMPS
BREATHER HOSES
DUST SEALS
COLLAR
LOWER MOUNTING BOLT
BOOT BAND SCREW
15-9
3/9/2008 11:08 PM