Honda 2005-2008 RX500 FA Service Manual page 86

'61HN252' by American Honda Motor Co. - Page 86 of 540
[2005-2008] [TRX500 FA/FGA]
MAINTENANCE
REAR FINAL GEAR CASE OIL AND
DIFFERENTIAL OIL
3-18
1 of 1
FINAL GEAR CASE OIL
LEVEL CHECK
Place the vehicle on a level surface.
Remove the oil check bolt and sealing washer,
check that the oil flows out of the check bolt hole.
Check for leakage if there is no oil flow.
Remove the oil filler cap and pour the oil slowly
through the filler hole until the oil starts to flow out
of the check bolt hole.
RECOMMENDED OIL: Hypoid gear oil SAE #80
Install the check bolt with a new sealing washer and
tighten it to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Coat a new O-ring with grease and install it into the
oil filler cap groove.
Install the oil filler cap and tighten it to the specified
torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
O-RING
OIL FILLER CAP
SEALING WASHER
OIL CHECK BOLT
OIL FILLER CAP
3/9/2008 10:40 PM