Honda 2005-2008 RX500 FA Service Manual page 262

'61HN252' by American Honda Motor Co. - Page 262 of 540
[2005-2008] [TRX500 FA/FGA]
CRANKSHAFT/AUTOMATIC TRANSMISSION
Be careful not to let
the connecting rod
press against the
crankcase mating
surface while
drawing.
13-12
1 of 1
CRANKSHAFT AND BALANCER
INSTALLATION
Apply engine oil to a new rear crankshaft bearing.
Drive the crankshaft bearing into the rear crankcase
with the marking side facing up.
TOOLS:
Driver 07749-0010000
Attachment, 78 x 90 mm 07GAD-SD40101
Pilot, 32 mm 07MAD-PR90200
For front crankshaft bearing replacement, see page
13-13.
Engage the balancer and crankshaft by aligning the
index lines on the side surfaces of the balancer
drive and driven gears and install the crankshaft and
balancer together into the rear crankcase.
Assemble the special tools onto the crankshaft.
Draw the crankshaft into the bearing inner race.
TOOLS:
Assembly collar 07965-VM00100
Assembly shaft 07965-VM00200
not available in U.S.A. or
07931-ME4010B and
07931-HB3020A
(U.S.A. only)
Threaded adaptor 07965-VM00300
not available in U.S.A. or
07931-KF00200
(U.S.A. only)
After installing the crankshaft in, make sure that the
index lines on the crank weight and balancer driven
gear are aligned.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
PILOT
BALANCER
CRANKSHAFT
CONNECTING
ROD
CRANKSHAFT
SHAFT
DRIVER
ATTACHMENT
Align
ADAPTOR
COLLAR
Aligned
3/9/2008 11:01 PM