Honda 2005-2008 RX500 FA Service Manual page 507

'61HN252' by American Honda Motor Co. - Page 507 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
4. ESP Shift Switch Inspection (Handlebar switch
side)
Check for continuity
'05, '06:
(Green) connector in
STEP 2 (page 24-28).
Check for continuity
After '06:
(Green) connector in
STEP 2 (page 24-28).
Is there normal continuity?
Faulty handlebar switch (shift switch)
No
Open or short circuit in wire between
YES
the ECM and the shift switch
5. System Failure Reproduction
Connect all connectors.
Turn the ignition switch ON.
Check the gear position indicator.
Is problem code 7 indicated?
· No problem (Temporary failure)
NO
· Erase the failure code
YES Faulty ECM After replacement, per-
form initial setting procedure.
PROBLEM CODE 8: ECM EEPROM
(WRITING/READOUT CIRCUIT)
1. Initial Setting Procedure
Perform initial setting procedure
Turn the ignition switch OFF and ON.
Check the gear position indicator.
Is the problem code blink indicated?
NO · No problem (Temporary failure)
· Erase the failure code
Faulty ECM After replacement, per-
YES
form initial setting procedure.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
at the switch side 10P
the same manner as the
at the switch side 14P
the same manner as the
'05, '06 shown:
GEAR POSITION INDICATOR
(page 24-6).
GEAR POSITION INDICATOR
HONDAMATIC
10P or 14P (GREEN) CONNECTOR
24-29
3/9/2008 11:29 PM