Honda 2005-2008 RX500 FA Service Manual page 374

'61HN252' by American Honda Motor Co. - Page 374 of 540
[2005-2008] [TRX500 FA/FGA]
FRONT DRIVING MECHANISM
17-26
1 of 1
Install the bearing into the compressor until it is
flush with the end of the tool.
TOOL:
Bearing compressor clip
Place the driver, attachment and pilot on the top of
the bearing and tape the driver to the compressor.
TOOLS:
Driver
Attachment, 22 x 24 mm
Pilot, 15 mm
Place the bearing and tool assembly into a freezer
for at least 30 minutes.
Heat the gear case to 80°C (176°F).
Take out the bearing and tool assembly from the
freezer and drive the bearing into the gear case
using the special tools.
Only strike the driver once. If you strike it more than
once, the ring may slip out of the groove. If this hap-
pens, remove the ring and bearing, and install a
new ring.
Make sure that the stopper ring is securely set in the
groove of the gear case.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
07YME-HN4010A
07949-3710001
07746-0010800
07746-0040300
COMPRESSOR
PILOT
NEEDLE BEARING
DRIVER
COMPRESSOR
STOPPER RING
3/9/2008 11:15 PM