Honda 2005-2008 RX500 FA Service Manual page 211

'61HN252' by American Honda Motor Co. - Page 211 of 540
[2005-2008] [TRX500 FA/FGA]
Install with the
spring's open ends
1 of 1
Install the clutch weights and springs onto the drive
plate as shown.
facing in.
Install the following:
inner plate with dished side facing up
clutch spring with concaved side facing down
outer plate with locating pins facing up
Install the E-clips into the pin grooves of the drive
plate with their gaps facing towards the locating
pins while compressing the cone spring with pliers.
Apply oil to the sprag clutch whole surface and the
sprag clutch contacting surface of the clutch drum.
Install the sprag clutch into the clutch drum with the
"OUT SIDE" mark facing up.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
WEIGHTS
INNER PLATE
LOCATING PINS
E-CLIPS
LOCATING PINS
"OUT SIDE" MARK
CENTRIFUGAL CLUTCH
SPRINGS
CONE SPRING
OUTER PLATE
SPRAG CLUTCH
10-13
3/9/2008 10:54 PM