Honda 2005-2008 RX500 FA Service Manual page 229

'61HN252' by American Honda Motor Co. - Page 229 of 540
[2005-2008] [TRX500 FA/FGA]
Be sure to press
the bearing in
evenly and flush
with the surface.
1 of 1
Loosen the starter driven pulley bolt, and remove
the pulley holder, bolt and pulley.
Check the starter motor shaft bearing.
Replace the bearing if the inner race does not turn
smoothly, quietly, or if the outer race fits loosely in
the alternator cover.
To replace the bearing:
Heat the alternator cover and remove the bearing
using the special tools.
TOOLS:
Bearing remover shaft, 10 mm
Bearing remover head, 10 mm
Remover weight
Drive a new bearing in the cover using the special
tools.
TOOLS:
Driver 07749-0010000
Attachment, 24 x 26 mm 07746-0010700
Pilot, 10 mm 07746-0040100
Apply molybdenum oil solution to the reduction
gear teeth, shaft journals and gear A shaft.
Install the following:
starter reduction shaft
starter reduction gear C and washer
starter reduction gear A and shaft
alternator cover (page 11-10)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
ALTERNATOR/STARTER CLUTCH
STARTER MOTOR
SHAFT BEARING
07936-GE00100
07936-GE00200
07741-0010201 or
07936-371020A or
07936-3710200
(U.S.A. only)
REDUCTION
GEAR A
WASHER
REDUCTION SHAFT
SHAFT
REDUCTION
GEAR C
11-15
3/9/2008 10:56 PM