Honda 2005-2008 RX500 FA Service Manual page 287

'61HN252' by American Honda Motor Co. - Page 287 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
Once the tool is in place, turn the adjusting bolt as
necessary to make the jaws parallel.
Then hand-tighten the pressure bolt and recheck the
jaws to make sure they are still parallel.
Tighten the pressure bolt with a wrench until the
ball joint stud pops loose.
Remove the two brake hose clamp bolts.
Remove the bolts and lower arm guard if necessary.
Remove the following:
front shock absorber lower mounting nut and
bolt
pivot nut, bolt and upper arm
pivot nuts, bolts and lower arm
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
FRONT WHEEL/SUSPENSION/STEERING
PRESSURE BOLT
ADJUSTING BOLT
BOLTS
BOLTS
UPPER BOLT/NUT
LOWER BOLTS/NUTS
LOWER ARM GUARD
SHOCK ABSORBER
LOWER MOUNTING
BOLT/NUT
14-19
3/9/2008 11:04 PM