Honda 2005-2008 RX500 FA Service Manual page 399

'61HN252' by American Honda Motor Co. - Page 399 of 540
[2005-2008] [TRX500 FA/FGA]
Be sure to wear
heavy gloves to
avoid burns when
handling the heated
gear case. Using a
torch to heat the
gear case may
cause warpage.
Using tape, attach
the Differential
Compressor to the
driver attachment.
1 of 1
PINION NEEDLE BEARING
Remove the stopper ring by rotating it until the end
of the stopper ring appears in the access hole.
Strike gently near the end of the ring with a punch
to bent the end upward.
Grasp the end of the ring with needle-nosed pliers
and pull the stopper ring out through the access
hole.
Heat the gear case to 80°C (176°F) and remove the
needle bearing by using the special tool.
TOOLS:
Bearing remover head, 14 mm 07WMC-KFG0100
Remover shaft
Remover weight
Install the stopper ring into the groove using special
tool.
TOOLS:
Differential Bearing
Clip Compressor
Heat the gear case to 80°C (176°F) and freeze the
pinion bearing on ice or in a freezer.
Drive the pinion bearing into the gear case using the
special tools.
Bearing Clip
TOOLS:
Driver
Attachment, 22 x 24 mm
Pilot, 14 mm
Make sure that the stopper ring is securely set in
groove of gear case.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
STOPPER RING
07936-KC10100
07741-0010201
07936-3710200 or
07936-371020A
(U.S.A. only)
COMPRESSOR
07YME-HN4010A
(U.S.A. only)
07749-0010000
07746-0010800
07746-0041200
PILOT
STOPPER RING
REAR DRIVING MECHANISM
BEARING
ACCESS HOLE
STOPPER RING
DRIVER
ATTACHMENT
18-17
3/9/2008 11:17 PM