Honda 2005-2008 RX500 FA Service Manual page 154

'61HN252' by American Honda Motor Co. - Page 154 of 540
[2005-2008] [TRX500 FA/FGA]
ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL
7-4
1 of 1
Drain the engine oil (page 3-14).
Drain the coolant from the engine (page 6-5).
Remove the following:
left and right center mud guards (page 2-7)
left and right front mud guards (page 2-8)
right and left inner fender (page 2-9)
exhaust system (page 2-14)
carburetor (page 5-6)
heat guard (page 8-6)
bolt and ground cable terminal
Remove the rubber cap, terminal nut and starter
motor cable.
Remove the bolt and ground cable.
Disconnect the crankcase breather hose from the
cylinder.
Free the control motor and angle sensor wires from
the wire band and clip, and disconnect their connec-
tors.
Remove the front differential mounting bolts, nuts
and bracket.
Move the front differential forward.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
GROUND CABLE TERMINAL
BOLT
BREATHER HOSE
RUBBER BOOT
STARTER MOTOR CABLE
CONTROL MOTOR
CONNECTOR
WIRE BAND
FRONT DIFFERENTIAL
10 mm
BOLT
BRACKET
GROUND CABLE
NUT
BOLT
ANGLE
SENSOR
CONNECTOR
WIRE CLIP
10 mm BOLT/
SPACER/NUT
8 mm BOLT/NUT
8 mm BOLTS
3/9/2008 10:48 PM