Honda 2005-2008 RX500 FA Service Manual page 361

'61HN252' by American Honda Motor Co. - Page 361 of 540
[2005-2008] [TRX500 FA/FGA]
Be careful not to
damage the oil seal
in the differential
Do not get grease
onto the shoe
Do not get grease
onto the shoe
1 of 1
Install the drive shaft by holding the inboard joint
until the stopper ring seats in the groove of the dif-
ferential.
gear case.
Make sure that the stopper ring is seated properly
by pulling out the inboard joint lightly.
Install the wheel hub/knuckle assembly over the
drive shaft and onto the suspension arms.
linings. Install hub nut, and temporarily tighten the nut.
Install and tighten each joint nut to the specified
torque and further tighten until its grooves align
with the cotter pin holes.
Install and tighten each joint nut to the specified
torque and further tighten until its grooves align
with the cotter pin hole.
linings.
TORQUE: 54 N·m (5.5 kgf·m, 40 lbf·ft)
Install new cotter pins.
Install the splash guard and tighten the bolts.
TORQUE: 11 N·m (1.1 kgf·m, 8 lbf·ft)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
FRONT DRIVING MECHANISM
WHEEL HUB/KNUCKLE ASSEMBLY
OUTBOARD JOINT
COTTER PINS
SPLASH GUARD
INBOARD JOINT
NUT
BOLTS
17-13
3/9/2008 11:13 PM