Honda 2005-2008 RX500 FA Service Manual page 316

'61HN252' by American Honda Motor Co. - Page 316 of 540
[2005-2008] [TRX500 FA/FGA]
REAR WHEEL/SUSPENSION
15-12
1 of 1
Install a new grease holder into the swingarm pivot.
Drive a new outer race into the swingarm pivot until
it is fully seated, using the special tools.
TOOLS:
Driver
Attachment, 37 x 40 mm
Apply lithium based grease (Shell 6459) to new
bearing rollers and dust seal lips and install the
bearings into the swingarm pivots.
INSTALLATION
Apply molybdenum disulfide grease to the output
shaft spline and install the universal joint onto the
output shaft.
Set the swingarm into the frame and install the left
and right pivot bolts.
Install the universal joint boot onto the swingarm.
Tighten the left pivot bolt.
TORQUE: 112 N·m (11.4 kgf·m, 82 lbf·ft)
Tighten the right pivot bolt.
TORQUE: '05'06: 10 N·m (1.0 kgf·m, 7 lbf·ft)
After '06: 3.9 N·m (0.4 kgf·m, 0.9 lbf·ft)
Move the swingarm up and down several times to
seat the pivot bearings.
Retighten the pivot bolts to the same torques.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
07749-0010000
07746-0010200
DRIVER
ATTACHMENT
RIGHT PIVOT BOLT
OUTER RACE
GREASE HOLDER
BEARINGS
BOOT
UNIVERSAL JOINT
LEFT PIVOT BOLT
3/9/2008 11:09 PM