Honda 2005-2008 RX500 FA Service Manual page 206

'61HN252' by American Honda Motor Co. - Page 206 of 540
[2005-2008] [TRX500 FA/FGA]
CENTRIFUGAL CLUTCH
10-8
1 of 1
Coat new O-rings with oil and install them onto the
oil joint pipe.
Install the oil joint pipe into the crankcase.
Coat a new O-ring with engine oil and install it into
the crankcase groove.
Install the dowel pins.
Clean the crankcase and cover mating surfaces.
Apply liquid sealant to the mating surface of the
front crankcase cover.
Install the front crankcase cover and tighten the
fourteen bolt in a crisscross pattern in 2 or 3 steps.
Install the control motor (page 24-43).
Coat a new O-ring with engine oil and install it onto
the oil feed pipe.
Install the oil feed pipe into the front crankcase
cover, aligning the tab with the groove in the cover.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
O-RINGS
DOWEL PINS
O-RING
BOLTS
FRONT CRANKCASE COVER
O-RING
TAB
OIL JOINT PIPE
CONTROL MOTOR
GROOVE
OIL FEED PIPE
3/9/2008 10:54 PM