Honda 2005-2008 RX500 FA Service Manual page 265

'61HN252' by American Honda Motor Co. - Page 265 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
Remove the output shaft oil seal.
Remove the balancer bearing with the special tools.
TOOLS:
Balancer bearing:
Bearing remover, 17 mm 07936-3710300
Remover handle 07936-3710100
Remover weight 07741-0010201 or
07936-371020A or
07936-3710200
Apply engine oil to new bearings.
Drive the following bearings in with the marking
side facing up using the special tools.
TOOLS:
Crankshaft bearing:
Driver 07749-0010000
Attachment, 78 x 90 mm 07GAD-SD40101
Pilot, 40 mm 07746-0040900
Balancer bearing:
Driver 07749-0010000
Attachment, 37 x 40 mm 07746-0010200
Pilot, 17 mm 07746-0040400
Output shaft bearing:
Driver 07749-0010000
Attachment, 42 x 47 mm 07746-0010300
Pilot, 25 mm 07746-0040600
Apply engine oil to a new output shaft oil seal lips
and install it until it is flush with the crankcase.
Install the oil pump (page 4-12).
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
CRANKSHAFT/AUTOMATIC TRANSMISSION
PILOT
OUTPUT SHAFT
OIL SEAL
BALANCER
BEARING
BEARING REMOVER
DRIVER
ATTACHMENT
OUTPUT SHAFT
OIL SEAL
13-15
3/9/2008 11:01 PM