Honda 2005-2008 RX500 FA Service Manual page 500

'61HN252' by American Honda Motor Co. - Page 500 of 540
[2005-2008] [TRX500 FA/FGA]
HONDAMATIC
Be extremely
careful not to
distort or apply
any force to the
grommet or
water may enter
the control
motor.
Do not use a
thin wire
because a large
amount of
current flows.
24-22
1 of 1
6. Control Motor Line Inspection
Disconnect the ECM 5P (Black) connector and
the control motor 2P (Natural) connector.
Check for continuity on the Green/red wire and
the Orange wire between the ECM connector
and main harness side motor connector.
Is there continuity?
Open in wire between the ECM and the
NO
control motor
YES GO TO STEP 7.
7. Control Motor Circuit Inspection
Disconnect the control motor 2P (Natural) con-
nector.
Check for continuity between the motor side
connector terminals.
Is there continuity?
NO Faulty control motor
YES GO TO STEP 8.
8. Control Motor Inspection
Remove the control motor from the crankcase
(page 24-43).
Connect the battery directly to the control motor
side connector terminal and check whether the
control motor rotates.
Does the control motor rotate?
NO Faulty control motor
GO TO STEP 9.
YES
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
G/R
O
G
O
G
O
G/R
O
3/9/2008 11:29 PM