Honda 2005-2008 RX500 FA Service Manual page 335

'61HN252' by American Honda Motor Co. - Page 335 of 540
[2005-2008] [TRX500 FA/FGA]
Note the installation
direction of the pad
1 of 1
ASSEMBLY
CALIPER BRACKET
PAD SPRINGS
CALIPER
PISTON
DUST SEAL
Replace the dust seal and piston seal with a new
one.
Be sure that each part is free from dust or dirt
before reassembly.
Coat a new piston seal with clean brake fluid.
Coat a new dust seal with silicone grease.
Install the piston seal and dust seal into the groove
of the caliper body.
Coat the caliper piston with clean brake fluid and
install it into the caliper cylinder with its closed ends
facing the caliper.
Install the pad spring onto the caliper bracket.
Replace the caliper and bracket pin boots if they are
spring.
worn, deteriorated or damaged.
Apply silicone grease to the boots inner surface.
Install the boots and caliper bracket.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
CALIPER PIN BOOT
BRAKE PADS
PISTON SEAL
BRACKET PIN
BRACKET PIN BOOT
CALIPER BRACKET
BRAKE SYSTEM
CALIPER PIN
CALIPER BODY
PISTON SEAL
DUST SEAL
PISTON
PAD SPRING
BOOTS
16-17
3/9/2008 11:10 PM