Honda 2005-2008 RX500 FA Service Manual page 212

'61HN252' by American Honda Motor Co. - Page 212 of 540
[2005-2008] [TRX500 FA/FGA]
CENTRIFUGAL CLUTCH
Keep the clutch
drum and drive
plate as an
assembly.
10-14
1 of 1
Apply engine oil to the sprag clutch contacting sur-
face of the drive plate boss.
Install the drive plate assembly into the clutch drum
while turning it counterclockwise.
Install the washer onto the crankshaft.
Apply engine oil to the clutch drum sliding surface
of the crankshaft.
Install the centrifugal clutch assembly onto the
crankshaft while aligning the splines of the drive
plate boss and crankshaft.
Engage the primary drive gear of the clutch drum
with the driven gear of the automatic transmission
unit.
Install the washer.
Apply engine oil to the threads and seating surface
of a new clutch lock nut and install it.
Install the special tools by aligning the pins with the
grooves in the drive plate.
Hold the drive plate and tighten the lock nut
TOOLS:
Clutch holder 07ZMB-HN2A100
(U.S.A. only)
clutch holder plate 07ZMB-HN20100
holder plate pin 07ZMB-HN20200
TORQUE: 118 N·m (12.0 kgf·m, 87 lbf·ft)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
DRIVER PLATE
CENTRIFUGAL CLUTCH ASSEMBLY
WASHER
CLUTCH HOLDER
CLUTCH DRUM
WASHER
LOCK NUT
3/9/2008 10:55 PM