Honda 2005-2008 RX500 FA Service Manual page 404

'61HN252' by American Honda Motor Co. - Page 404 of 540
[2005-2008] [TRX500 FA/FGA]
REAR DRIVING MECHANISM
18-22
1 of 1
Clean the mating surfaces of the gear case.
Coat a new O-ring with grease and install it into the
groove in the gear case.
Install the final drive assembly onto the swingarm.
Install four new nuts, and loosely tighten the nuts.
Connect the breather hose to the hose joint of the
gear case.
Coat a new O-ring with grease and install it into the
groove in the gear case.
Install the right axle housing onto the gear case and
swingarm with the four bolts and eight new nuts.
Tighten the four final drive assembly mounting nuts
TORQUE: 54 N·m (5.5 kgf·m, 40 lbf·ft)
Tighten the four axle housing mounting nuts.
TORQUE: 44 N·m (4.5 kgf·m, 33 lbf·ft)
Install the right rear shock absorber into the axle
housing and tighten the lower mounting bolt.
TORQUE: 44 N·m (4.5 kgf·m, 33 lbf·ft)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
BREATHER HOSE
NUTS
O-RING
NUTS
BOLTS/NUTS
RIGHT AXLE
HOUSING
LOWER MOUNTING BOLT
O-RING
FINAL DRIVE
ASSEMBLY
3/9/2008 11:19 PM