Honda 2005-2008 RX500 FA Service Manual page 485

'61HN252' by American Honda Motor Co. - Page 485 of 540
[2005-2008] [TRX500 FA/FGA]
If the gear position
indicator shows the
constant display of
"N" or the control
motor did not cycle,
turn the ignition
switch OFF and
procedure from
1 of 1
6. Move the drive mode select switch to D1 or D2.
7. Turn the ignition switch ON while pushing both
the UP and DOWN shift switches (ESP shift
switches) simultaneously (Do not release the
shift switches yet).
Wait a moment and check that the "N" blinks at
the gear position indicator.
8. Immediately release both the UP and DOWN
shift switches, then push and release the shift
switches in the order of UP, DOWN and UP (Do
not hold onto the switch).
· A constant "--" should be displayed on the gear
position indicator.
· Listen for the control motor operation sound (the
control motor should function at this time to
adjust the angle sensor).
9. Within 5 seconds of the display of "--" and while
repeat the
the control motor is operating, move the throttle
lever from the fully closed position to the fully
step 7 .
opened position, and then move it to the fully
closed position again.
10.When the initial setting is complete, the indica-
tion on the gear position indicator changes from
the constant display of "--" to the constant dis-
play of "N."
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
DRIVE MODE SELECT SWITCH
UP
DOWN
GEAR POSITION INDICATOR
HONDAMATIC
THROTTLE LEVER
24-7
3/9/2008 11:27 PM