Honda 2005-2008 RX500 FA Service Manual page 397

'61HN252' by American Honda Motor Co. - Page 397 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
Install the special tools onto the pinion gear shaft
and gear case.
TOOLS:
Pinion puller base
Puller shaft
Pull the pinion gear assembly out of the gear case.
PINION GEAR BEARING/SHIM
REPLACEMENT
Pull the pinion gear bearing from the shaft with a
commercially available bearing puller.
Remove the pinion gear shim.
Install the shim and bearing onto the pinion gear.
· When the gear set, ring gear bearing, and/or gear
case has been replaced, use a 2.00 mm (0.79 in)
thick shim for initial reference.
Drive the bearing with the marking side facing up.
TOOLS:
Driver, 40 mm I.D.
Attachment, 30 mm I.D.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
07HMC-MM80110 or
07HMC-MM8011A
(U.S.A. only)
07931-ME40000 or
07931-ME4010B and
07931-HB3020A
(U.S.A. only)
07746-0030100
07746-0030300
ATTACHMENT
REAR DRIVING MECHANISM
PULLER SHAFT
PULLER BASE
PINION GEAR
BEARING
SHIM
DRIVER
18-15
3/9/2008 11:17 PM