Honda 2005-2008 RX500 FA Service Manual page 499

'61HN252' by American Honda Motor Co. - Page 499 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
2. Initial Setting Procedure
Perform initial setting procedure (page 24-6).
Is initial setting procedure completed?
NO GO TO STEP 4.
YES GO TO STEP 3.
3. ESP Shift Switch Operation Inspection
With the engine running, put the gearshift lever
in the D range and the mode select switch ESP,
and operate the shift switches to shift to each
speed range 1st through 5th.
Is it possible to operate?
NO GO TO STEP 4.
YES · No problem (Temporary failure)
· Erase the failure code (page 24-9)
4. Control Motor Power Input Line Inspection
Turn the ignition switch OFF.
Disconnect the ECM 5P (Black) connector.
Measure the voltage between the wire harness
side connector terminal.
Connection: Red/yellow (+) Ground ()
Does the battery voltage exist?
NO · Blown control motor fuse (30A).
· Open in wire between the ECM and
the battery
YES GO TO STEP 5.
5. Control Motor Ground Line Inspection
Turn the ignition switch OFF.
Disconnect the ECM 5P (Black) connector.
Check for continuity between the wire harness
side connector terminal.
Connection: Green (+) Ground ()
Is there continuity?
NO Open in wire between the ECM and
ground
GO TO STEP 6.
YES
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
UP
DOWN
HONDAMATIC
R/Y
G
24-21
3/9/2008 11:28 PM