Honda 2005-2008 RX500 FA Service Manual page 360

'61HN252' by American Honda Motor Co. - Page 360 of 540
[2005-2008] [TRX500 FA/FGA]
FRONT DRIVING MECHANISM
for
See page 17-11
band installation
direction.
17-12
1 of 1
Adjust the length of the drive shaft to the figure
given below.
DRIVE SHAFT LENGTH: Left: 363.2 mm (14.30 in)
Right: 383 mm (15.08 in)
Install a new boot band C and a new boot band B
onto the inboard joint boot.
Bend down the band end and secure it with the lock
tabs. Tap the lock tabs with a plastic hammer.
Install a new boot band C and a new outboard boot
band onto the outboard boot.
Bend down the band end and secure it with the lock
tabs. Tap the lock tabs with a plastic hammer.
INSTALLATION
Install a new stopper ring into the groove in the
inboard joint splines.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
BAND END
BAND C
BAND B
BAND A
TAB
BAND C
INBOARD JOINT
TABS
TAB
STOPPER RING
3/9/2008 11:13 PM